Bookmark and Share Email this page Email Print this page Print Feed Feed

Swedish Club publishes new guidance on engine room fires

Jan 31, 2019 09:09 AM

Case studies show that proper preparation and training can limit damage and injury

Courtesy The Swedish Club

The following is text of a news release from The Swedish Club:

(GOTHENBURG, Sweden) — Engine rooms on ships have all the ingredients for a fire – oxygen, heat and flammable liquids under pressure. With an average cost of $1.85 million, engine room fires cost nearly six times more than the average for H&M claims in general. Yet the quality of the crew’s response can have a significant impact not only on the cost of the fire, but more importantly on the safety of those on board.

In response to this, The Swedish Club has published "Dealing with Engine Room Fires," a publication which provides an insight into three major incidents dealt with by the club that involve engine room fires. 

The case studies describe the situation in detail, and feature commentary provided by Peter Stalberg, senior technical advisor at The Swedish Club. “Preventing an engine room fire is the priority, but the time and effectiveness of the response is almost as important," he said. "Although a crew has taken all reasonable precautions, an engine room fire can still occur without warning.

“A swift and effective response within a few minutes may limit the damage to soot washing and less than $200,000 in costs. Yet I have seen cases where delaying the response or failing to operate the fire extinguishing system properly, has allowed the fire to intensify and spread, causing severe damage and cost more than $3 million.”

"Dealing with Engine Room Fires" investigates three engine room fires involving a passenger service vessel (PSV), a container vessel and a bulk carrier. These real-life incidents were all dealt with very differently by the crew, clearly demonstrating the importance of preparation and training.

“Of course prevention must always be at the forefront of our approach to these incidents," Stalberg said. "Not surprisingly, one of the dominating causes is lube-oil or fuel-oil mist spraying onto hot surfaces and then igniting. The SOLAS requirements concerning oil piping in engine rooms are clear; all types of oil pipes must be screened and flanges protected so that any eventual leak will not spray onto a hot surface. Any surface with a temperature above 220 degrees Celsius must be thermally insulated.

“Over time, however, when overhauling engine room machinery and removing/refitting exhaust pipes, the insulation will deteriorate. An exhaust pipe system insulated to 95 percent is not good enough – it must be 100 percent intact – always.”

"Dealing with Engine Room Fires" can be downloaded on www.swedishclub.com.

Add your comment:
Edit Module