NTSB: Failure to monitor position at anchor led to Lower Miss. collision

51387936967 0dea6ed8fb O

(WASHINGTON) — A bridge team’s lack of effective monitoring of their position while at anchor led to a cargo ship hitting an anchored bulk carrier and striking a chemical dock on the Lower Mississippi River near New Orleans, according to a National Transportation Safety Board (NTSB) marine accident brief released Thursday.

Marine accident brief 21/15 details the NTSB’s investigation of the May 8, 2020, collision of the general cargo ship Nomadic Milde with the anchored bulk carrier Atlantic Venus. Nomadic Milde then struck a nearby chemical dock and grounded on the bank. The accident resulted in about $16.9 million in damage. There were no injuries.

51387936967 0dea6ed8fb O
Image from video taken from the bridge of Atlantic Venus with Nomadic Milde lying against its bow. NTSB photo

Nomadic Milde anchored in the Lower Mississippi River just upriver of Atlantic Venus during high water conditions. After setting the starboard and port anchors, Nomadic Milde’s positions and headings suggest that the ship did not hold in its original anchor position and likely dragged toward the bank while the ship’s pilot was departing the ship. It then dragged for a second time downriver and closer to Atlantic Venus, to about half the original distance between the two vessels.

In its report, the NTSB said there was no evidence of either watch officer of Nomadic Milde checking the ship’s position at frequent intervals or by means other than the electronic chart and information display system (ECDIS) watch alarm to determine if the ship was secure at anchor. According to the NTSB, there was sufficient evidence to alert the bridge team that Nomadic Milde was not holding well, and had this been detected, the master could have been alerted earlier. This would have allowed for sufficient time to undertake necessary measures to address the problem.

The NTSB determined the probable cause of the collision was the bridge team on Nomadic Milde not effectively monitoring the vessel’s position, and therefore not detecting that the vessel was dragging anchor and had moved from its original position during high water conditions in proximity to other vessels.

“Monitoring a ship at anchor, especially in an area where the risks of nearby hazards and weather and current are present, requires a continuous state of vigilance and the use of all available means to determine whether a vessel is dragging or not,” the report said. “Although ECDIS is a useful tool in determining a ship’s position at anchor, the ship’s radars would have provided information for the crew to determine or crosscheck if the range to a vessel or object had decreased, or if the ship had moved while at anchor.”

Click here to read the complete report.

– National Transportation Safety Board

By Professional Mariner Staff